THINNER FOR CAR BODY LIQUID RUBBER 1 X 500 ML

PRODUCT INFORMATION Our newly developed FOLIATEC.com Carbody Spray Film is the new generation of removable body coatings. The Carbody Spray Film is not only suitable for professional and large-area applications on complete vehicles, but also for rims, mirrors, motorcycles and much more. FOLIATEC.com is one of the first producers to offer ready-to-spray metallic colors. Ready to use in 2.0-2.5mm spray nozzles, Carbody Spray Film can be applied like a normal lacquer on car bodies using a spray gun or our FOLIATEC.com spray system. And the best: the applied coating can be easily removed at any time without any assistive tools. ready to use sufficient for partial coating of cars and full coating of two wheelers very good opacity attractive appearance and a smooth spray result protection against scratches, salt, weather conditions and chipping on the original paint UV resistant applicable on any surface non-absorbent easy to remove 1 liter is enough for a max. of approx. 2 square meters Product Tip: Best in combination with our FOLIATEC.com Carbody Spray Film Thinner to adjust viscosity. Green-purple magic tip: We recommend applying two coats of matte black with a flash time of 10 minutes, then applying two coats of green-purple magic. Important: Matte Black must be dry before applying Magic Green-Purple. Depending on the amount of thinner, it lasts about 3 hours. APPLICATION All parts of the car that can be easily removed must be disassembled. Mask all surfaces that are not to be coated. Mask the rubber stamps with Easy Up Tape from FOLIATEC.com (Item #79920). You should also protect the wheel housings and the underside of the vehicle from spray mist. Clean and dry the surface to be sprayed, including edges, then degrease with the FOLIATEC.com Body Spray Film Pre-Filter (Item #79934). After cleaning, remove any remaining dust with a feather duster. Application with the FOLIATEC.com Spray System: Apply FOLIATEC.com Carbody Spray Film in 4 to 5 generous coats. On horizontal surfaces (roof or hood), work at a slow pace and at level 1 or 2: set the quantity control on the spray gun handle to level IIII. On vertical surfaces, work at a medium rate and level 2. If necessary, reduce the amount control on the spray gun handle. Only use in suitable workshops and garages. Reduce ventilation if working in a spray booth. Spray Gun Application: Apply FOLIATEC.com Carbody Spray Film in 4 generous coats at medium speed. Use a 2 to 2.5mm spray nozzle at 3 to 5 bar pressure in a suitable spray booth. Flash for 10 minutes after each spray coating, done. Note: After 60 minutes, Carbody Spray Film is completely dry. After 24 hours, the vehicle is ready to drive again. For detailed information, please refer to the instruction manual.