CAR BODY LIQUID RUBBER URBAN SILVER METALLIC MATT 1 X 5L CANISTER

PRODUCT INFORMATION Our newly developed FOLIATEC.com Carbody Spray Film is the next generation of removable body coatings. Carbody Spray Film is not only suitable for professional and large-area applications on complete vehicles, but also for wheels, mirrors, motorcycles and many more. FOLIATEC.com is one of the first producers to offer ready-to-spray metallic colors. Ready for use on 2.0-2.5mm spray nozzles, Carbody Spray Film can be applied like a normal lacquer on car bodies using a spray gun or our FOLIATEC.com spray system. And the best: the applied coating can be easily removed at any time without any help tools. ready to use enough for partial coating of cars and full coating of two-wheelers very good opacity attractive appearance and a smooth spray result protection against scratches, salt, weather conditions and chipping in the original paint UV resistant applicable on any surface non absorbent easy to remove 1 liter is enough for a max. of approx. 2 square meters Product Tip: Optimal in combination with our Carbody FOLIATEC.com Spray Film Thinner to adjust viscosity. Green-purple magic tip: We recommend applying two coats of matte black with a 10 minute flash off time, then applying two coats of green-purple magic. Important: Matte Black must be dry before applying Magic Green-Purple. Depending on the amount of thinner, it lasts for about 3 hours. APPLICATION All parts of the car that can be easily removed must be disassembled. Mask off all surfaces that should not be coated. Mask rubber stamps with Easy Up Tape from FOLIATEC.com (item # 79920). You should also protect the wheel housings and underside of the vehicle from spray mist. Clean and dry surface to be sprayed, including edges, then degrease with FOLIATEC.com Auto Body Spray Film Pre-Filter (Item # 79934). After cleaning, remove the remaining dust with a feather duster. FOLIATEC.com Spray System Application: Apply FOLIATEC.com Carbody Spray Film in 4-5 generous coats. On horizontal surfaces (roof or hood), work slowly and at level 1 or 2: set the quantity control on the spray gun handle to level IIII. On vertical surfaces, work at a medium pace and level 2. If necessary, reduce the amount control on the spray gun handle. Only use in suitable garages and workshops. Reduce ventilation if working in a spray booth. Spray Gun Application: Apply FOLIATEC.com Carbody Spray Film in 4 generous coats at medium speed. Use a 2 to 2.5 mm spray tip with a pressure of 3 to 5 bar in a suitable spray booth. Flash for 10 minutes after each spray coating, done. Note: After 60 minutes, Carbody Spray Film is completely dry. After 24 hours, the vehicle is ready to drive again. For detailed information, refer to the instruction manual.