PRODUCT INFORMATION Hard Rock Liner Base Layer acts as the base for our Hard Rock Liner. It was developed to make Hard Rock Liner removable again. ready to spray can be painted with FOLIATEC.com Hard Rock Liner ? easy to remove APPLICATION Disassemble all car parts that can be easily removed. Mask all surfaces that are not to be coated. Mask the rubber stamps with Easy Up Tape from FOLIATEC.com (Item #79920). You should also protect the wheel housings and the underside of the vehicle from spray mist. Clean and dry the surface to be sprayed, including edges, then degrease using FOLIATEC.com Carbody Spray Film Pre-Filter (Item #79934). After cleaning, remove any remaining dust with a feather duster. Hard Rock Liner Basecoat Application with the FOLIATEC.com DIY Spray System: Apply Hard Rock Liner Basecoat in 2 generous coats. Work at a medium pace on level 2 and set the amount control on the pistol grip to level III or IIII. Spray Gun Application: Apply Hard Rock Liner Base Coat in 2 generous coats at a medium rate. Use a 2.0mm spray nozzle at 2 - 3 bar pressure in a suitable spray booth. Flash for 30 minutes after the first spray coat. Note: It can be covered with Hard Rock Liner once completely dry (after 4 - 5 hours at 20 ° C depending on the thickness of the layers). For further instructions, read the APPLICATION sheet.
