Operation: The air filters are responsible for cleaning the air that enters the engine, normally the filters that are mounted as standard are made of paper, since they are cheaper and less noisy. The goal of the replacement filters and direct intake kits is to achieve a higher flow of cold air and thus I can apply two coats of green-purple magic. Important: Matte black must be dry before applying Magic Green-Purple. Depending on the amount of thinner, it lasts about 3 hours. APPLICATION All parts of the car that can be easily removed should be disassembled. Mask all surfaces that are not to be coated. Mask rubber stamps with FOLIATEC.com Easy Up Tape (item #79920). You should also protect the wheel housings and the underbody of the vehicle from spray mist. Clean and dry the surface to be sprayed, including edges, then degrease with FOLIATEC.com Body Spray Film Pre-Filter (item #79934). After cleaning, remove any remaining dust with a feather duster. Application with FOLIATEC.com Spray System: Apply FOLIATEC.com Carbody Spray Film in 4-5 generous coats. On horizontal surfaces (roof or hood), work slowly and on level 1 or 2: set the amount control on the spray gun grip to level IIII. On vertical surfaces, work at a medium pace and level 2. If necessary, reduce the amount control on the spray gun grip. Only use in suitable workshops and garages. Reduce ventilation if working in a spray booth. Spray Gun Application: Apply FOLIATEC.com Carbody Spray Film in 4 generous coats at medium speed. Use a 2-2.5mm spray nozzle with 3-5 bar pressure in a suitable spray booth. Flash for 10 minutes after each spray coating, done. Note: After 60 minutes, Carbody spray film is completely dry. After 24 hours, the vehicle is ready to drive again. For detailed information, please refer to the instruction manual.
